![background image](http://html1.mh-extra.com/html/lutron-electronics/grafik-eye-qs/grafik-eye-qs_installation-and-operation-manual_1950621046.webp)
Setting Limits
(for wired window treatments only)
Note:
Entering Limit Setup mode may
cause window treatments to move
approximately 200 mm up or
down.
Be sure that each window
treatment is positioned so that the
fabric can safely move 200 mm
up or down before entering Limit
Setup mode .
1. On any shade button group, press and
hold simultaneously the top and raise
buttons. The LEDs next to the top and
bottom buttons will cycle.
At any time while in Limit Setup mode,
you can move all window treatments
together to their current open limit by
double-tapping the top button, or to their
current close limit by double-tapping the
bottom button.
Note:
Window treatment electronic
drive units (EDUs) must first be
associated to a shade button group
before its limits can be adjusted.
2. Select the EDU you want to adjust using
the top button on the shade button
group. Each time you press and release
the top button, a different EDU that is
assigned to that shade button group will
open and close in an 200 mm range to
indicate it is selected.
Tap the top button until the EDU for the
window treatment you wish to adjust
moves. (You can also use the bottom
button, which moves through the
assigned EDUs in the opposite order.)
3. Adjust the currently selected EDU to
the desired level for the open limit (the
maximum the window treatment is
allowed to open) using the raise and
lower buttons.
4. Press and hold the top button on the
shade button group for 5 seconds to
store the current position as the open
limit. The LED next to the top button will
flash quickly for 2 seconds.
5. Adjust the currently selected EDU to
the desired level for the close limit (the
maximum the window treatment is
allowed to close) using the raise and
lower buttons.
6. Press and hold the bottom button on
the shade button group for 5 seconds
to store the current position as the close
limit. The LED next to the bottom button
will flash quickly for 2 seconds.
7. Repeat steps 2 through 6 to set the
open and close limits for each window
treatment assigned to the shade button
group.
8. Press and hold simultaneously the top
and raise buttons on the shade button
group to exit Limit Setup mode.
Note:
Remote limits cannot be set
for Sivoia
®
QS wireless window
treatments through the GRAFIK
Eye
®
QS control unit. Limits must
be set manually at the wireless
window treatment EDU. (See
the Sivoia
®
QS wireless shade
instructions.).
®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 46
OK
1
2
3
4
5
6
9
10
11
12
13
14
7
8
15
16
9-16
1-8
Adjusting Window Treatment Settings
(for Wired and Wireless Sivoia
®
QS Window Treatments)