![background image](http://html1.mh-extra.com/html/lutron-electronics/grafik-eye-qs/grafik-eye-qs_installation-and-operation-manual_1950621042.webp)
®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 42
The QS IR Eye offers advanced programmable scene control depending on the IR remote being used.
Use the chart below to select the appropriate control mode on the GRAFIK Eye
®
QS control unit:
IR Remote
Control Mode
GRX-IT
4 Buttons & Off or 5 Buttons
GRX-8IT
8 Buttons & Off
MIR-ITFS
Favorite or Zone control
C-FLRC
Favorite or Zone control
Third Party IR Remote
Default
Associating the QS IR Eye with a GRAFIK Eye
®
QS control unit:
Note:
For use with Lutron remote models GRX-IT and GRX-8IT, or with
third-party IR remotes.
1. Point the IR remote at the QS IR Eye. To enter programming mode, press and
hold the top and bottom buttons on the remote for 3 seconds until the LED on
the QS IR Eye begins to flash slowly.
2. Press and hold the top scene button on the GRAFIK Eye
®
QS control unit for
3 seconds. The scene LEDs will flash to confirm that the QS IR Eye has been
associated. Press the OK button to continue.
3. Use the Master buttons to select “Scene” and press the OK button to accept.
4. Use the Master buttons to select one of the scene control types (listed below)
to correspond to the IR remote that will be used with the QS IR Eye. Press the
OK button to accept.
If “Default” was not selected, the info screen will prompt you to select which
scene will correspond to the top button of the IR remote. Use the Master
buttons to select the desired scene, and press the OK button to accept. The
info screen will confirm that your settings have been saved.
Note:
The “Default” scene control type will activate whichever scene command
is transmitted to the GRAFIK Eye
®
QS control unit.
5. Point the IR remote at the QS IR Eye. To exit programming mode, press and
hold the top and bottom buttons on the remote for 3 seconds.
Button Setup
First
Scene
1
IR Setup
Saved
Saved
OK
1
2
3
4
5
6
9
10
11
12
13
14
7
8
15
16
9-16
1-8
Press and
hold the
top scene
button
for 3
seconds to
associate
QS IR Eye
Master
buttons
OK
button
IR Eye
Change type?
Press OK
Change type?
Scene
QS IR Eye
Change type?
Default Scene
LED
GRX-IT
GRX-8IT