®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 35
Daylight Sensor Setup
This step allows you to assign sensors to zones on the GRAFIK Eye
®
QS control unit.
Each zone can be assigned to only one sensor, but sensors can be assigned to more
than one zone.
Selecting Sensors
1. If not already done, associate daylight sensors.
2. Use the Master buttons to highlight “Setup” and press the
OK button to accept. Available sensors will be displayed.
3. Use the Master buttons to scroll through the sensors until the
one you wish to assign or unassign is highlighted, and press the
OK button to select it.
4. Use the zone raise and lower buttons for the desired zones to
assign or unassign the sensor to those zones. The zone raise
button assigns the displayed sensor, and the zone lower button
unassigns it. Press the Timeclock (back) button to return to the
list of available sensors. Repeat for additional sensors.
Calibrating the Sensors
1. Put any wireless Radio Powr Savr
TM
daylight sensors associated
with the desired zones into Calibrate Mode: Press and hold the
“Cal” button for 6 seconds until the sensor flashes.
Note:
After 5 minutes, Calibrate Mode will timeout, and the
sensor will return to normal mode.
2. Press the Timeclock (back) button to return to the Daylight
Sensor screen. Use the Master buttons to highlight “Calibrate”
and press the OK button to accept.
3. Use the Master buttons to select the desired zone and press the
OK button to accept.
4. Use the Master buttons to select the desired light level for the
zone, and press the OK button to accept. Repeat for all zone
levels you wish to calibrate.
5. Exit programming mode.
Note:
If wireless sensors are not found, verify that they are
associated correctly.
Sensor
Set Zones
OK
OK
Zone raise: Press to
assign the displayed
sensor
Zone lower: Press to
unassign the desired
sensor
Daylight Sensor
Calibrate
Setup
Sensor x/y
xxxx-xxxx
RF
Saved
Saved
3 seconds
Daylight Sensor
Setup
Calibrate
Saved
Searching
OK
Master
buttons
OK
button
Timeclock
(back) button
Sensor Name
Zone 1
Adjust Light
More light
Less light
Cal
button
Radio Powr Savr
TM
Daylight Sensor
