Luminex Ethernet - DMX8 / WiFi, User Manual

Page: 18 / 54

Frame rate setting
The frame rate setting determines the DMX refresh rate. The refresh rate
is set for all outlets similar. The frame rate can be set from 20 to 40 FPS
(Frames Per Second).
Break time setting
The break time of the DMX signal can be set from 92 – 352 us. This is the
idle time between 2 DMX packets of 512 channels.
Mark After Break (MAB) time setting
The MAB time of the DMX signal can be set from 12 – 88 us. This is the
time after the idle time to indicate a new DMX packet start.
Page 18 of 54 Ethernet - DMX8 / WiFi
> > > > > > >> > >
<< < < < < < < < <
+
Enter
Enter
>>
< <
Enter Enter
DMX Config
< Outlet Route > DMX Config
< FrameRate > DMX Config
< Break time > DMX Config
< MAB time > DMX Config
< Output time
DMX Config
Break : 210 uS
Save setup ?
CONFIRM > Save setup ?
< CANCEL
Enter
> > > > > > > >
< < < < < < < <
+
Enter
Enter
> >
< <
Enter Enter
DMX Config
Outlet route > DMX Config
< FrameRate > DMX Config
< Break Time > DMX Config
< MAB Time > DMX Config
< Output Time
DMX Config
FPS : 36
Save setup ?
CONFIRM > Save setup ?
< CANCEL
Use Up and Down keys to change the DMX
frame rate setting (20-44 fps).
Use Up and Down keys to change the
DMX break time setting (92 -352
uS).
> > > > > > >> > >
<< < < < < < < < <
+
Enter
Enter
> >
< <
Enter Enter
DMX Config
< Outlet Route > DMX Config
< FrameRate > DMX Config
< Break time > DMX Config
< MAB time > DMX Config
< Output time
DMX Config
MAB : 50 uS
Save setup ?
CONFIRM > Save setup ?
< CANCEL
Use Up and Down keys to change the DMX
MAB setting (12-88 uS).