Luminex Ethernet - DMX8 / WiFi, User Manual

Page: 13 / 54

Outlet route
➢ DMX output
To setup an outlet as output, follow the following procedure.
Choose
DMX Config, Outlet route
press
Enter
and select the outlet with
the left right keys.
Enable
Yes Enables the outlet
No Disables the outlet
Dir (Direction)
Output Sets the outlet as DMX output
Input Sets the outlet as DMX input
Mode (output)
Single The DMX outlet outputs normal DMX data coming in over ArtNet.
Zero DMX outlet outputs DMX data with all zero values for all 512 channels.
Univ (Universe)
Sets the outlet's DMX line address. ArtNet Hexadecimal value is available in brackets
Ethernet - DMX8 / WiFi Page 13 of 54
Select with up and down keys to enable or to disable the
outlet. When disabled no further configuration is needed.
Select INPUT or OUTPUT direction of DMX outlet
Set the DMX output mode: SINGLE or ZERO
Select the DMX line address. The combined ArtNet
universe address is shown in brackets. This is the
combination of the outlet's subnet and subswitch.
Set merging of ArtNet DMX packages of different IP
sources on or off.
When IP merging enabled you can choose between
HTP, LTP or CST (Custom mode).
> > > > > >
<< << < <
+
Enter
> > > >
<< <<
Enter
N O
YES Enter
+
-
OUTPUT Enter INPUT Enter
Enter
Enter
Enter
> >
<<
Enter Enter
DMX Config
Outlet route >
DMX Config
< FrameRate
DMX Config
< Break Time
DMX Config
< MAB Time
DMX Config
Outlet : 1 >
DMX Config
< Outlet : 2 >
DMX Config
< Outlet : 8
Outlet : 1
Enable : YES
Outlet : 1
Dir: OUTPUT
Outlet : 1
Dir: INPUT
Outlet : 1
Mode : SINGLE
Outlet : 1
Univ: 0 (00)
Outlet : 1
IP Merging: OFF
Save setup ?
CONFIRM >
Save setup ?
< CANCEL