Lucent Technologies PortMaster, Configuration Manual

Page: 247 / 364

Using Office-to-Office Connections 15-11
Configuration Steps for an Office-to-Office Connection
Configuring Dial-Out Location Settings
You must create a location entry on the PortMaster in Paris for the London office. This
entry allows the PortMaster in Paris to call the PortMaster in the London office when
network traffic is queued. Configure a new location
london with the values shown in
Table 15-9.
Table 15-9 Location Table Values
Setting Command
Location name add location london
Protocol set location london protocol ppp
IP destination set location london destination 192.168.200.1
Netmask set location london netmask 255.255.255.0
IPX network set location london ipxnet F2
(When configuring the IPX network number for the location,
you must set a number that is different from the one on the
Ethernet at either end.)
RIP routing set location london rip on
MTU set location london mtu 1500
Compression set location london compression on
Idle timer set location london idle 5
High-water mark set location london high_water 0
Dial group set location london group 0
Telephone number set location london telephone 5551212
Username set location london username paris
Password set location london password anything
Maximum ports set location london maxports 1