Lucent Technologies PortMaster, Configuration Manual

Page: 272 / 364

Configuration Steps for Dial-In Access
17-8 PortMaster Configuration Guide
After you configure the ports as shown in Table 17-4, enter the following commands to
reset the ports and save the configuration:
Command> reset all
Command> save all
Configuring Users
Because no more than approximately one hundred users can be configured in the user
table and stored in nonvolatile memory on the PortMaster, you should use RADIUS for
user authentication when configuring multiple PortMaster Communication Servers to
handle more than a few dozen users each. This example assumes the use of RADIUS.
If you are not using RADIUS, configure dial-in and network users in the user table.
RADIUS Settings
Table 17-5 lists the RADIUS setting for the first PortMaster. For information about
RADIUS parameters, refer to the
RADIUS Administrator’s Guide or access the information
via FTP from ftp://ftp.livingston.com/pub/le/radius/radius.install .
Table 17-5 RADIUS Values
Setting Command
Secret set secret anyvalue
Authentication server set authentic 192.168.1.2
Alternate authentication server set alternate 198.168.1.3
(This setting is optional. This secondary server
must have a RADIUS database identical to that
on the primary authentication server.)
Accounting server set accounting 192.168.1.2
Alternate accounting server set accounting 2 192.168.1.3
(This setting is optional.)