Lucent Technologies PortMaster, Configuration Manual

Page: 243 / 364

Using Office-to-Office Connections 15-7
Configuration Steps for an Office-to-Office Connection
Dial-Out Location Settings for London
You must create a location entry on the PortMaster Office Router in the London office
for the Paris office. This entry allows the Office Router in the London office to call the
PortMaster 2 in the Paris office when network traffic is queued. The new location
paris
should be configured with the values shown in Table 17-5.
Note – Configuring the maximum ports setting to a value higher than 0 causes the
PortMaster to dial out to a continuous location, or become available for dial-out to an
on-demand location. By configuring the maximum ports setting last, you ensure that
the PortMaster will not attempt to make a connection with a location until you have
configured all the settings for that location.
Table 15-5 Location Table Values
Setting Command
Location name add location paris
Type set location paris manual
Protocol set location paris protocol ppp
IP destination set location paris destination 192.168.1.1
Netmask set location paris netmask 255.255.255.0
IPX network set location paris ipxnet F2
RIP routing set location paris rip on
MTU set location paris mtu 1500
Compression set location paris compression on
Idle timer set location paris idle 5
High-water mark set location paris high_water 0
Dial group set location paris group 1
Telephone set location paris telephone 5551212
Username set location paris username London
Password set location paris password anypasswd
Maximum ports set location paris maxports 1
✍