Lucent Technologies PortMaster, Configuration Manual

Page: 219 / 364

Using Frame Relay 13-13
Frame Relay Subinterfaces
Adding a Location
To configure a Frame Relay subinterface, you add a location for each interface, configure
it with the frame protocol, and associate it with a dial group. Then associate a
synchronous port with the same dial group. For example, to create a location called
sub1 , enter the following commands:
Command> add location sub1
Command> set location sub1 protocol frame
Command> set location sub1 group 1
Command> set s1 group 1
The rest of the location table entries are set as described in Chapter 8, “Configuring Dial-
Out Connections,” including setting an IP address, routing, and filtering for each
interface.
Creating a DLCI Entry
The next step in configuring the subinterfaces is to create an entry in the DLCI table.
Entries can be followed with an optional IP address or hostname. The keyword
ipxdlci
is available for IPX networks.
To create a DLCI table entry for the subinterface sub1 , enter the following commands:
Command> add ipdlci sub1 16
Command> add ipdlci sub1 19 192.168.2.19
Command> add ipdlci sub1 20 192.168.2.20
Command> add ipxdlci sub1 21 0e0a001e
To remove an entry, enter the following commands:
Command> delete dlci sub1
Command> delete ipxdlci sub1 21
Displaying DLCI Entries
DLCI entries that are added or deleted are linked to the location table. Use the show
location Locname command to display the DLCI entries.