Lucent Technologies PortMaster, Configuration Manual

Page: 135 / 364

Configuring Dial-Out Connections 8-7
Configuring the Location Table
Setting RIP Routing
You can associate RIP routing with locations—for example, a dial on-demand
connection where the remote router is defined as a location on the local PortMaster.
As described in the PortMaster Routing Guide , PortMaster products automatically send and
accept route information as RIP messages.
Refer to the PortMaster Routing Guide for OSPF and BGP configuration instructions.
To set RIP routing for a location, use the following command:
Command> set location Locname rip on | off | broadcast | listen
Table 8-2 describes the results of using each keyword.
Note – ComOS releases prior to 3.5 use routing instead of the rip keyword.
Table 8-2 Keywords for Configuring RIP Routing
Keyword Description
on The PortMaster broadcasts and listens for RIP packets from
this network interface when it is established.
off The PortMaster neither broadcasts nor listens for RIP packets
from this network interface when it is established. This is the
default.
broadcast The PortMaster broadcasts RIP packets to this network
interface when it is established.
listen The PortMaster listens for RIP packets from this network
interface when it is established.
✍