Lucent Technologies PortMaster, Configuration Manual

Page: 199 / 364

Using ISDN BRI 12-15
ISDN BRI Unnumbered IP Configuration Example
Note – Configuring the maximum ports setting to a value higher than 0 causes the
PortMaster to dial out to a continuous location, or become available for dial-out to an
on-demand location. By configuring the maximum ports setting last, you ensure that
the PortMaster will not attempt to make a connection with a location until you have
configured all the settings for that location.
After you configure location table settings as shown in Table 12-7, enter the following
command to save the configuration:
Command> save all
For more information about configuring location table parameters, refer to Chapter 8,
“Configuring Dial-Out Connections.”
Configuring the PortMaster in San Francisco
The PortMaster in San Francisco is being configured for an ISDN dial-up connection to
the PortMaster in Denver.
IPX network set location sf ipxnet F3
RIP routing set location sf rip on
MTU set location
sf
mtu
1500
Idle timer set location
sf
idle
2
Dial group set location
sf
group
2
Username set location
sf
username
sf
Telephone number set location
sf
telephone
5551212
Password set location
sf
password
anypasswd
High-water mark set location
sf
high_water
0
Maximum ports set location
sf
maxports
1
Table 12-7 Location Table Values (Continued)
Setting Command
✍ ✍