B-2
MAX 3000 Installation and Basic Configuration Guide
Upgrading the MAX 3000
Changing memory modules
Changing memory modules
To change a memory module, you remove the MAX unit’s system try, locate and remove the
existing card, replace the card, and put the system tray back into the cover.
!
Caution:
When installing any card or module, be sure to follow proper procedures (such as
using a grounding mat and a wrist strap) to prevent buildup of static electricity.
Remove the system tray from the MAX cover
To remove the system tray from the MAX cover, perform the following steps:
1
Make sure the MAX power is off and the power cord is unplugged.
Warning:
Failure to turn off the MAX power and unplug the power cord could result in
bodily injury.
2
Facing the back panel of the MAX, locate the screws that hold the system tray and cover
together.
3
Use a #2 Phillips screwdriver to loosen the screws holding the system tray to the cover.
4
Use the system tray pull-ring to slide the system tray a few inches from the cover.
System tray pull-ring
Screws holding system tray to cover
LA
N U
TP
LN
K
CO
L
TX
RX
WA
N 2
WA
N 3
WA
N 4
WA
N 5
WA
N 6
CO
NT
RO
L
SE
RIA
L
DP
LX
10
0B
T
WA
N 1
