Clarity
Record
Operator Manual
Page 147
Record to Existing Cue-list
23.2.5
Contents Options
When recording a
New Cue-list
, setting “Playback” to either “Tracking” (Default) or “Cue
Only” will automatically select the appropriate “Contents Options” for playback in that mode.
However you can change these options if you desire or select exactly which attribute groups
you want to include in the cue.
You can choose which attribute groups (
Intensity
,
Position
,
Colour
and
Beam
) are
included in each cue by clicking on them. When an attribute group is Green, it is
included. Clarity includes all attribute groups by default.
If you are merging a new cue into an existing cue you can choose to
Preserve existing
timing
of the existing cue.
Selected Fixtures only
check box.
The fixture attribute information that is recorded into a cue is usually dependent on the
settings of 4 Radio Buttons listed below. It doesn't matter if the fixtures are still selected
in the current programmer session or not. However, by placing a tick in the check box,
you can further filter the recorded information by limiting it to include
Selected
Fixtures only
.
The following four Radio Buttons are mutually exclusive. Selecting one deselects all others.
Exclude redundant state
(changes only)
.
This only records the changes that have been made in the programmer since the last
cue was recorded. All other grabbed values in the programmer are considered as
redundant and are excluded from the cue.
This cue is suitable for tracking playback and is automatically selected if you set a new
cue-list to ‘Tracking’ playback mode in the Record Cue dialog box.
For example, if intensity is set to 100% in cue 1 and you record the same intensity into
cue 2, then the intensity information will not be recorded since it would already exist in
the cue-list and will track forward from cue 1 when cue 2 is played back in tracking
mode.
