Loop Telecom IP6610, User Manual

Page: 177 / 190

Chapter 21 Appendix A: Operation Commands
154
Command: >activate DS1 pattern
Syntax: activate DS1 pattern type
Explanation: Send test pattern in all DS1 channels.
Parameters: type 3-in-24/1-in-8/2-in-8/1:1
Command:
>activate DS1 bert
Syntax: activate DS1 bert type
Explanation: Send QRSS in DS1 channels.
Parameters: type full send QRSS in all DS1 channels(24 channels)
wan1 send QRSS in the channels which assigned to wan1 interface
idle send QRSS in idle channels
Command: >add timeslot wan1
Syntax: add timeslot wan1 start[stop]
Explanation: Assign DS1 timeslots to wan1 interface.
Parameters: start The number of the starting time slot (1~24)
[stop] The number of the last time slot (1~24)
Command: >delete timeslot wan1
Syntax: delete timeslot wan1 start[stop]
Explanation: Delete DS1 timeslots from wan1 interface.
Parameters: start The number of the starting time slot (1~24)
[stop] The number of the last time slot (1~24)
Command: >delete performance
Syntax: delete performance
Explanation: Delete user performance data.
Parameters: none
Command: >release bert
Syntax: release bert
Explanation: Stop DS1 bert function.
Parameters: none
Command: >release loopback
Syntax release loopback
Explanation: Stop DS1 loopback function.
Parameters: none
Command: >release remote_loopback
Syntax: release remote_loopback remote_loopback_deactivate_code_type
Explanation: Send remote loopback deactivate code to far end.
Parameters: remote_loopback_deactivate_code_type in-band/at&t-payload/
ansi-payload/ansi-line
Command:
>release pattern
Syntax: release pattern
Explanation: Stop pattern function.
Parameters: none