Loop Telecom IP6610, User Manual

Page: 133 / 190

Chapter 21 Appendix A: Operation Commands
110
Table 21-2 E1 Command Lines
E1 Command Lines
Command Parameters Description Br. Rt. Access
loopback loopback-type
line, payload
activate an E1 diagnostic loopback V V Admin
pattern type
3-in-24/1-in-8/2-in-8/1:1
activate test pattern V V Admin
activate
bert type
Full/wan1/idle
activate E1 line BERT V V Admin
timeslot wan_intf
wan1
start TS
1-31
[endTS]
1-31
add
Add timeslot wan1 1-16
add one or more E1 timeslots to wan1 net address V V Admin
timeslot wan_intf
wan1
start TS
1-31
[ endTS]
1-31
remove one or more timeslots from wan1 V V Admin
performance
delete E1 performance data V V OP
bert
release E1 bert V V Admin
loopback release an E1 loopback V V Admin
delete
pattern
release E1 pattern V V Admin
frame framing mode FAS/none set E1 line framing V V Admin
code coding mode AMI/HDB3
set E1 line coding mode V V Admin
crc setting on/off enable/disable E1 CRC V V Admin
idle_code idle code 0x00  0xff
set E1 unused channel idle code V V Admin
rai setting on/off
enable/disable E1 RAI V V Admin
mf setting on/off enable/disable E1 TS16 multiframing V V Admin
primary_clk clock source
line/internal
set E1 primary clock source V V Admin
secondary_c
lk clock source
line/internal
set E1 secondary clock source V V Admin
set E1
timer
timing 0  86400
Set E1 diagnostic function timer V V Admin