Loop Telecom IP6610, User Manual

Page: 84 / 190

Chapter 13 Remote Bridge Setup
61
Set the bridge age. Key in the command set bridge age followed by your choice for the bridge age value.
Then press the Enter key. The values you can choose from are 10–1000000. We chose 300 seconds as
this is the same as the early 802.1d default aging time of five minutes.
Set the WAN 1 timeslot. Key in the command add timeslot wan1 followed by the timeslots you wish to
add. Then press the Enter key. In our sample setup we chose to add timeslots 1-31 so we keyed in the
admin
add timeslot wan1 1 31 and then pressed the Enter key.
If you are going to use management on bridge mode you must also add the following admin commands:
1. Key in
set bridge ip 140.132.254.254 255.255.0.0 . Then press the Enter key.
2. Key in set bridge gateway 140.132.1.1 255.255.0.0. Then press the Enter key.
Delete lan1 wan1