Chapter 21 Appendix A: Operation Commands
147
Command:
>show fwinfo
Syntax:
show fwinfo
Explanation:
Show firmware information.
Parameters:
none
Command:
>show hwinfo
Syntax:
show hwinfo
Explanation:
Show device hardware information.
Parameters:
none
Command:
>show lan1 ip
Syntax:
show lan1 ip
Explanation:
Show current LAN1 IP address.
Parameters:
none
Command:
>show lan1 statistics
Syntax:
show lan1 statistics [update period]
Explanation:
Show statistics information of LAN1.
Parameters:
Update period
If the update period has been applied (in seconds), the statistical
information will be refreshed every update period. If the update
period has not been applied, the statistical information is displayed
only once.
Command:
>show mac
Syntax:
show mac
Explanation:
Display the MAC table regardless of the VLAN state
Parameters:
None
Command:
>show nat
Syntax:
show nat [mode]
Explanation:
show NAT configuration including NAT/NAPT setting on each interface and active
NAT/NAPT translations.
Parameters:
mode
the mode can be either “nat” or “napt”. It will show information only
Command:
>show rate_limit
Syntax:
show rate_limit
Explanation:
Displays all the policies in the policy list for WAN1 interface..
Parameters:
none
Command:
>show route
Syntax:
show route [all]
Explanation:
Show current routing table.
Parameters:
all
If the command is issued without this keyword, only the static routing table will be
shown. If the command is issued with this keyword, all routing entries including
static routes and dynamic routes will be shown.
Command:
>show serial
Syntax:
show serial
Explanation:
Shows the device’s serial number.
Summary of Contents for IP6610
Page 2: ...2011 Loop Telecommunication International Inc All rights reserved Version 33 23 MAR 2011...
Page 76: ...Chapter 11 Port Forwarding Virtual Service 53...
Page 79: ...Chapter 12 QoS 56 Figure 12 1 QoS Application...
Page 119: ...Chapter 20 Setting Up Firmware Configuration Up Download with TFTP Server 96...
