LONGHORN LHD8003, Installation Manual

Page: 20 / 33

8.3.8.1 Device
For the system to recognize individual devices, each device must be registered . For example, if the device
is a wireless transmitter, registration enables the system to identify the source of a received transmission.
Each device has an individual encrypted ID code. Registering the device to the system familiarizes the
system with this code.
Version
It enables you to query the version of the control panel.
To query the version of panel:
1. From the menu, select “ Service ” → “#” → “ Version ” .
2. The panel version will display. Press to quit .
→ “#”
“
*
”
To register by code learn:
1. Select Programming” ” Device” ” Zone” WL. Register” By Code Learn “ → “# → “ → “# → “ → “ → “#” “ ”.
2. Select the zone number ending with “#”. If registered before , it will remind you to re - register . Press “#” to
There are two ways of register: by code learn or input.
→
8.3.8 Programming Set
WL. Zone 3
Type: Entry/Exit
TX Loss
Activate Siren
Low Battery
Keyfob 1
Low Battery
TX test is to test and identify wireless signal. With signal received from registered transmitter, it will display
info of it, including ID. With signal received from unregistered transmitter, it will indicate as unknown signal.
T o text TX: 1. From the menu, select “ Service ” → “#”
2. The voice will guide “ Transmitter test starts, transmit wireless signal !”
3. Trigger the transmitter, If it is registered, the info will display on LCD. If it isn’t registered, it
will indicate as unknown signal.
4. Press “ ” to quit after test finish .
GSM Test
To ensure the validity of GSM communication , please test the signal network at the installing position.
→ “ Transmitter ” → “#” → “ TX test ” → “#”.
*
-35- -36-
To test GSM signal:
From the menu, select “ Service ” → “#” → “ GSM ” → “#” . → “ GSM Test ” → “#”
Note : Signal strength: 0-31
，
31 means the strongest . To make sure the normal communication ,
please confirm it is over 12 .
Volume Set
7. GSM Test
No Signal!
It enables you to activate or mute the siren and meanwhile adjust the volume. If the siren volume is
closed, the speaker volume will be the lowest.
To set volume:
1. From the menu, select “ Service ” → “#” → “ Audio ” → “ Volume ” “# ”. → “# ” →
2. Press the navigation key to select volume level, ending with “#”. Press “
*
” to quit .
3. Trigger the wireless asap to avoid any interference.
4. The system will remind to save after receiving the signal. Press “#” to save , or “ ” to re - register .
*
continue , or “ ” to quit . If not registered before , the voice will remind “ Start enrolling, transmit now !”
with counting down for 60 s .
*
During register, if the signal is received for registered code, it will indicate as registered. If the
code is in wrong format, it will indicate as wrong. If no code is received within 60s, the system
indicate
“
Enrolling failed!
”
Note
1. WL. Register
1
2. By Code Input
. By Code Learn
1. Zone
2. Clear WL.
3. Set Zone Type
4. Zone Siren Set
5. Chime Zone
1. WL. Register
1. Devices
2. Keyfob
3. Siren
4. WL. Superv.
1. Zone
Set
WL. Register