Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
18
5831 Series
Installation and Operating Instructions
Setting Descriptions
Opening Time:
Following an activation signal, door moves from fully
closed to open check or 80°, whichever occurs first,
according to Table 1 .
NOTE:
Operator calculates time during Auto Setup .
Hold Open Time:
Hold open time is delay in open position before door
starts to close . Hold Open is adjustable from 1 - 30
seconds . ANSI 156 .19 requires a door to hold open
for a minimum of 5 seconds (default from factory) .
Closing Time:
Following Hold Open time, door moves from fully
open to close check or 10°, whichever occurs first,
according to Table 1 .
NOTE:
Operator calculates time during Auto Setup .
Close Check:
Close Check brings door to latch point without
slamming door . It occurs in last 10° of closing and
shall not be less than 1 .5 seconds .
Closing Force:
Door shall not close with a force greater than 6 .8 kg
when measured at latch side of closing stile . Closing
force is adjustable to 3 .6 kg .
Open and Power Close Force:
Open and Power Close Force adjusts force operator
will apply in open direction . If optional Power
Close feature is turned on, Power Close Force will
be adjustable using this setting . Operator shall be
adjusted so that a stopped door will apply a force in
opening direction of 6 .8 kg or less . If optional Power
Close feature is enabled, door shall be adjusted so
that a stopped door will apply a force of less than 6 .8
kg in closing direction .
Option Features:
• Power Close: Operator will apply a small amount
of power if door did not close in expected close
time to assist in closing door . Power Close will
activate and turn off when door is fully closed or
if door does not move after attempting to close
for two (2) seconds .
• Push and Go: Operator will initiate an automatic
open cycle when door is manually moved in
open direction .
• Dynamic Braking: Operator will brake door if
excessive door speed (4 times programmed
Open Time) occurs . For example, from a wind
load or an abusive open condition .
• Latch Assist: Operator will apply a force in close
direction for 1/2 second when operator receives
an activation signal to assist an electric strike in
unlocking . When door closes, operator will apply
a force in close direction to assist in latching
door .
Executive Mode:
When Executive mode is activated, operator will
open door when it receives an activation signal and
door will remain open until a second activation
signal is received .
NOTE:
Power Close, Push and Go, Latch Assist, and
Executive Mode must only be enabled when unit is
powered using optional 24VDC power supply .
Table 1: Door Open and Close Time in Seconds
Door
Weight
(kg)
Door Width (mm)
915
960
1015
1060
1120
1220
23
3 .0
3 .0
3 .0
3 .0
3 .0
3 .0
34
3 .0
3 .0
3 .0
3 .0
3 .0
3 .1
45
3 .0
3 .0
3 .0
3 .2
3 .3
3 .6
68
3 .3
3 .5
3 .7
3 .9
4 .1
4 .4
90
3 .8
4 .0
4 .3
4 .5
4 .7
5 .1
115
4 .3
4 .5
4 .8
5 .0
5 .2
5 .7
