17
5831 Series
Installation and Operating Instructions
Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
Programming Operator
1 . Enter programming mode .
Press and hold both “SELECT” and “ENTER” buttons
until LEDs 1 - 4 flash green .
• Close Position LED will light red and remain lit .
2 . Program Door Closed position .
With door in closed position, press and release
“ENTER” button .
• Close Position LED will flash green briefly .
• Open Position LED will light red .
3 . Program Door Open position .
Open door fully and press and release “ENTER” button .
If ENTER button is not accessible with door in fully
open position, press and release any activation button .
• Open Position LED will flash green briefly .
• Auto Setup LED will light red .
4 . Perform Auto Setup .
Allow door to return to fully closed position and press
and release “ENTER” button .
• Door will rapidly open 30 to 45 degrees and then
close .
• Auto Setup LED will light green .
• Operator will store settings and exit programming
mode .
NOTE:
Refer to “Customising Settings” beginning on page
19
to adjust settings or enable optional features .
To reset controller:
• Press and hold “ENTER” button .
• While holding down “ENTER” button press and
release “RESET” button .
• LEDs 1 - 4 will flash green briefly .
NOTE:
Resetting controller does not reset RF
transmitters .
Figure 35
Linking Wireless Pushbuttons
Only one transmitter can be linked at a time .
Repeat procedure for up to twelve (12) 5831 Series
transmitters . This linking method does not overwrite
other RF controls previously programmed into
memory .
To link:
1 . Press and hold “LEARN” button on controller
until LEDs 1 - 4 flash green .
2 . Push wireless pushbutton .
• Close Position LED will flash green to
indicate that operator accepted this
wireless pushbutton .
3 . Repeat as necessary for additional transmitters .
To remove ALL from memory:
1 . While holding down “LEARN” button, press and
release “RESET” button until LEDs 1 - 4 flash
green .
CLOSE
POSITION
OPEN
POSITION
AUTO
SETUP
OPEN & CLOSE TIME
OPEN & PWR CLOSE
FORCE
HOLD OPEN/
EXECUTIVE
OPTIONS
PG
PC
LA
DB
4
3
2
1
LEARN
RESET
SELECT
ENTER
LEDs
1-4
Activation
Buttons
Thumb Wheel
Option Features
Power Close
Push & Go
Dynamic Braking
Latch Assist
Time and Force
Settings
