7
5831 Series
Installation and Operating Instructions
Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
Flush Mount
Large Reveal
Typical
Support Bracket
Location
In Shoe
16mm Min.
38mm Max.
DOOR
16mm Min.
38mm Max.
Support Bracket
Location
In Shoe
16mm Min.
38mm Max.
DOOR
DOOR
Stop Greater
Than 38mm
Mount to face of stop
Stop Less
Than 38mm
Mount to face of rabbet
Arm
Mounting
Shoe
Arm
Mounting
Shoe
DOOR
DOOR
Figure 7
1 . Measure door stop to determine if arm
mounting shoe will be installed to face of stop
or face of rabbet . (Figure 6)
2 . Determine frame location of triangular
support bracket . (Figure 7)
CAUTION:
In all cases, edge of shoe must be
between 16mm and 38mm from face of door .
• In a typical installation, bracket will set
flush against face of frame header .
• In a large reveal installation, bracket will
mount to underside of frame header .
• In a flush mount installation, bracket is not
used - ceiling covers face of frame . Shoe
should then be installed on underside of
frame header .
NOTE:
If used, triangular support bracket face
must be flush against face of frame header or
frame rabbet . Depending on frame conditions,
select one of three bracket locations on arm
mounting shoe so that support bracket is
mounted as securely as possible .
3 . Aligning centerline of shoe with shoe
centerline mark previously made from
template, mark hole locations using a center
punch and hammer . (Figure 8)
4 . Install arm mounting shoe and support bracket .
If door frame is aluminum:
a . Use a 25/64" bit to drill holes .
b . Using provided rivnut installation tool,
install ¼-20 steel rivnuts .
c . Install and tighten a minimum of three
(3) 19mm socket head cap-screws to
secure shoe and bracket to underside
and face of frame header .
NOTE:
When attempting to install rivnuts to
underside of door frame it may be necessary
to remove door stop .
If door frame is wood:
a . Use a 5/32" bit to drill holes .
b . Install and tighten a minimum of three
(3) #14 x 32mm wood screws to secure
shoe and bracket to underside and face
of frame header .
Install Arm Mounting Shoe and Support Bracket
PUSH SIDE Operator and Arm Installation
Figure 6
Mark Hole Locations
Mark Hole Locations
Figure 8
Top of Door
or
