Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
8
5831 Series
Installation and Operating Instructions
Install Arm Pivot (Figure 9)
1 . Slide arm pivot over arm shoe .
2 . Make sure that dimension from face
of door to centerline of door arm
mounting hole is 162mm .
3 . Tighten four (4) set screws to secure .
PUSH SIDE Operator and Arm Installation
Set Screws
Door
162mm
Set Screws
Figure 9
Install Operator Mounting Bracket
1 . Install operator mounting bracket to door
using locations marked in “Prepare Frame
and Door” section on page 6 . (Figure 10)
If door is aluminum:
a . Use 25/64" bit to drill operator
mounting bracket holes .
b . Using provided rivnut installation
tool, install bracket to door with
minimum four (4) ¼-20 steel rivnuts .
DO NOT TIGHTEN
If door is wood or hollow metal:
a . Use 3/8" bit to drill operator
mounting bracket holes .
b . Using 3/16" hex wrench, install
bracket to door with minimum four
(4) ¼-20 socket head cap-screws and
washers .
DO NOT TIGHTEN
NOTE:
For light duty or hollow
core doors with insufficient top rail
blocking, supplied through bolts or
sex nut and bolts are required .
2 . Adjust operator mounting bracket by
sliding bracket in slot holes . (Figure 11)
• If large stop, adjust bracket so there is
60mm space between top of bracket
and top of door .
• If standard mounting, adjust bracket
so there is 45mm space between top
of bracket and top of door .
• If narrow stile, adjust bracket so there
is 13mm space between top of bracket
and top of door .
3 . Tighten screws to secure operator
mounting bracket in position .
Figure 10
60mm,
45mm
or 13mm
Top of Door
Figure 11
or
or
