15
5831 Series
Installation and Operating Instructions
Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
Install Wireless RF Transmitter Pushbuttons
Make sure pushbuttons (Figure 30):
• are located 30cm to 3 .7m from door
• remain accessible from swing side when
door is opened
• are not located in a position where user
would be in path of moving door
• are mounted so that user is in full sight
of door when activating pushbutton
• are mounted between 86 .4cm
minimum and 121 .9cm maximum from
floor
Reference conformance to requirements set out
in AS1428 .1 and other applicable building codes
for additional information regarding accessibility
requirements for door and area around door .
1 . Remove face plate to access mounting
screws . (Figure 31)
2 . Using housing as a template, mark mounting
hole locations .
3 . Predrill holes into wall or door jamb if
necessary .
4 . Using a phillips head screwdriver, mount
pushbutton housing to surface .
5 . Replace face plate .
NOTE:
Included battery provides approximately
250,000 activations . See “Power Specifications”,
page 3
.
Remove face plate to replace battery .
Figure 30
Figure 31
Face Plate
Screws
Front View
Back View
121.9cm Max
86.4cm Min
To be reviewed in accordance with AS1428 .1
