Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
4
5831 Series
Installation and Operating Instructions
Australian Compliance Statement
Australia & New Zealand (RCM & R-NZ)
This product complies with all the applicable
requirements of the Regulatory Compliance Mark
(RCM) for Australia & New Zealand and Radio Spectrum
Management (R-NZ) requirements for New Zealand .
This product complies with the Class A requirements of
EN 55032: 2015 + AC: 2016 as per the RCM compliance
scheme EMC standards list .
Warning: This equipment is compliant with Class
A of EN 55032: 2015 + AC: 2016 . In a residential
environment, this equipment may cause radio
interference .
This product complies with the AS/NZS 4268: 2017
per the ACMA (RCM for Australia) and additional
requirements per the Radio Spectrum Management
(RSM for New Zealand) Radiocommuciations
requirements .
RCM Radiation Exposure Statement
This system has been evaluated for RF exposure for
Humans as referenced in the Australian Radiation
Protection standard and has been evaluated to the
ICNIRP (International Commission on Non-Ionizing
Radiation Protection) limits . This product has been
deemed to comply with the RF exposure limits under
the general public limits .
Battery Safety Information
Risk of explosion and personal injury if device is
installed into non compatible circuit . Do not open,
mutilate, or expose to conducting materials (metal),
moisture, liquid, fire or heat above 60 ° C (130° F),
incinerate, or immerse in water or liquid of any kind . Do
not short circuit . Doing so may cause batteries to leak
or explode, resulting in personal injury .
You assume all risk associated with the suitability,
installation and performance of this product and
other third party components, hardware, software and
services that you select
.
R-NZ
• Improper installation or adjustment may result in
personal injury or property damage . The operator
must be completely installed and programmed
or the door must be disabled prior to leaving the
site . An incomplete installation or unprogrammed
operator is a safety hazard . Follow all instructions
carefully .
For questions call ASSA ABLOY Opening
Solutions Customer Service .
• 5831 Series is intended for INTERIOR USE ONLY .
• Do not install 5831 Series on balanced doors or
doors with swing clear hinges .
• If unit will be wired to external power, do not
connect source of power until instructed to do so .
• Battery should be switched “OFF” until operator
and door arm installation are complete .
• An operating door creates pinch hazards . Be
careful making operating adjustments while door is
moving .
• Installation must comply with all local, state, and
national electrical codes . Also, power supply wiring
must be secured to prevent entrapment in moving
parts .
Precautions