9
5831 Series
Installation and Operating Instructions
Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
Operator Mounting
Bracket Cover
Operator Mounting
Pin (2)
Top Position
for Wide or
Medium Stile
Doors
Bottom Position
for Narrow Stile
Doors
PUSH SIDE Operator and Arm Installation
1 . Install operator mounting pins into
bracket using a large adjustable wrench .
(Figure 12)
• Narrow Stile Door: Use lower
threaded holes in mounting bracket .
• Wide or Medium Stile Door: Use
upper threaded holes in mounting
bracket .
2 . Install operator mounting bracket cover
by placing it over pins . (Figure 12)
3 . Remove bottom cover of operator .
(Figure 13)
4 . Remove battery pack from operator by
sliding it off T channel . (Figure 13)
5 . Insert two (2) ¼-20 x 38mm socket head
cap-screws into operator . (Figure 13)
6 . With battery pack side toward door
hinges, slide operator onto operator
mounting pins and tighten screws .
Mount Operator to Bracket
Figure 12
Figure 13
Mounting Screw Locations
T Channel
Battery
Pack
Operator
Bottom
Cover
Hinge Side of Door
