Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
10
5831 Series
Installation and Operating Instructions
Washer
(Use 2 if
necessary to
prevent rubbing)
Arm elbow must touch
face of door before
tightening bolts.
Tighten each
1/4 turn at a
bolt
time in a circular pattern until
all
are tight.
bolts
WARNING:
It is a safety hazard to install arm with
battery pack connected .
1 . With arm coupling bolts facing up and arm
elbow against door, place larger end of arm
onto pinion shaft . (Figure 14)
2 . With arm elbow still touching face of door,
tighten coupling bolts evenly (one quarter
turn at a time in a circular pattern) until
fully
tight
using 3/16" hex wrench . (Figure 14)
CAUTION:
Bolts must be tightened evenly for
arm to be installed properly to operator .
Install Arm
Figure 14
PUSH SIDE Operator and Arm Installation
Preload Arm
1 . Pull arm elbow 6mm away from face of door
to add tension . (Figure 15)
2 . While maintaining arm elbow position at
6mm, increase or decrease arm length by
twisting end link to align end link hole with
arm pivot hole . (Figure 15)
CAUTION
: Excessive preload will reduce
closing force of operator and may cause door
to stick in open position or arm to reverse .
NOTE:
Arm pivot can be adjusted if end link
hole cannot be aligned with arm pivot hole by
increasing or decreasing arm length .
• Loosen four (4) set screws securing arm
pivot to arm pivot bracket .
• Slide arm pivot as necessary to align hole
with end link hole .
• Tighten set screws .
3 . Using 3/16" hex wrench, attach end link to
arm pivot with washer and 5/16 -18 x 22mm
button head cap screw . (Figure 16)
NOTE:
If needed, an extra washer is supplied
to prevent rubbing between top of arm and
end link .
4 . Cycle door several times, and ensure that
door opens and closes smoothly .
Door
6mm
Arm
Pivot
(Attached
to Frame)
Frame
End Link
End Link Hole
Aligned With
Arm Pivot Hole
Figure 15
Figure 16
You’ve now installed the
5831 Series, PUSH SIDE Mount.
Go to “Install Battery Pack”, page 14 .
