Lissmac MULTICUT 550 GH, Operating Manual

Page: 49 / 92

49/92
7.12. Maneuvering the floor saw
WARNING
Risk of injury from rotating saw blade
By touching the rotating saw blade clothes can be pulled in and limbs severed.

Any movement of the machine outside the area where cutting work is to be performed must be
done using a non-rotating tool.
 Always pay attention to the surroundings while traversing and drive at a suitable speed.
WARNING
Hazards in the work area
The running machine can be a potential source of injury if not used responsibly and used and operated as
prescribed.
 The operator has to remain behind the handlebars during all cutting operation

The floor saw may only be operated by a single person. Instruct other persons to clear the work
area. Cordon off work area if required.
Maneuvering
the floor saw

Disengage traction drive (Pos. 8).
 Raise saw blade with switch (Pos. 7) to have ample ground clearance.

Deactivate the water pump with switch (Pos. 2).

Set engine throttle forward to idle (Pos. 4).

Stop engine and wait for saw blade to spin out to a standstill.

Set Gearbox for blade drive to freewheel (N)
 Start engine (Pos. 1)

Release parking brake (Pos. 9) and engage traction drive (Pos. 8).

Drive machine to new position (Pos. 6).
4
7
6
2
8
1
9