Lissmac MULTICUT 550 GH, Operating Manual

Page: 30 / 92

30/92
4.7. Replacing and tensioning v-belts
WARNING
Cut and crush hazard from rotating v-belt drive
When touching the rotating v-belt, hands and clothing can become entangled and pulled in, resulting in cut,
and crush injuries including dismemberment.

Do not open or remove the belt guard or touch the v-belt while it rotates.
 Only perform this work with the engine turned off and pulleys standing still.
SG
Approved belts 14 pc. XPA 1732 antistatic
Installation or
replacement of belts

Remove bolts (Pos. 1) an belt drive guard

Loosen locking bolt (Pos. 2), and slacken the belts with tension bolt (Pos. 3) evenly on both sides
 Remove worn belts, check sheaves for damage and wear and install new belts

Tension belts evenly on both sides to the colored marking (Pos. 4)
Always apply even tension to both sides when tensioning the belts (same number of notches)

Tighten locking bolt (Pos. 2)
NOTICE
Belt replacement
Do not mix different belt types or manufacturers. We strongly recommend exchanging belts as a full
matching set. Especially mixing used and new belts will reduce service life of new belts by half.
1
3
2
4