Lissmac MULTICUT 550 GH, Operating Manual

Page: 16 / 92

16/92
2.4.4. Maneuvering the floor saw
The floor saw may only be relocated when the saw blade is standing still.
Before leaving the operating position on the floor saw, the internal combustion engine must be
switched off and the saw blade must be standing still.
A rotating saw blade poses a serious cut hazard.
2.4.5. Special work while using the machine
Observe the adjustment, maintenance and inspection work and intervals specified in this operating
manual including the details for replacing parts/ parts of the equipment. These activities may only be
accomplished by authorized technical personnel.
When the floor saw has been shut down completely for maintenance and repair work, it must be
secured and marked to prevent it from accidental activation.
Before cleaning, cover and seal all openings, into which no cleaning agent may penetrate for safety
and/or function reasons. Electric motors, switches and plug connectors are at particular risk. Remove
the covers/masking tape completely after finishing the cleaning work.
Always retighten all screw connections loosened during maintenance and repair work.
If the disassembly of safety devices is necessary for setup, maintenance and repair, they are to be
reassembled and checked immediately after conclusion of maintenance or repair work.
Never use a rotating tool, with a maximum speed rating lower than the rated speed of the machine.
2.5. Note relating to special types of danger
2.5.1. Dangers for the operator from the machine
Before leaving the operating position on the floor saw, the internal combustion engine must be
switched off and the saw blade must be stationary.
The internal combustion engine of the floor saw must only be used as intended:
Propel the floor saw and drive the saw blade.
The outlet of the exhaust pipe must always point away from the operator. Do not inhale exhaust fumes.
The exhaust pipe gets hot during operation. Avoid contact and wear personal protective equipment.