Lissmac MULTICUT 550 GH, Operating Manual

Page: 47 / 92

47/92
7.11. Cutting operation
WARNING
Destruction of the saw blade from lack off cooling water
If the saw blade is not supplied with a sufficient amount of cooling water, the blade can overheat and
cutting segments may break off. Grinding dust is not bound effectively.

Always ensure a sufficient supply of cooling water for the diamond blade

Wear personal protection equipment
WARNING
Destruction of the sawblade by abrupt lowering
If the saw blade is lowered abruptly, the blade can get bent and cutting segments may break off.

Lower saw blade gradually
 Set up a safety zone around the cutting area
 Wear personal protection equipment
Always perform straight cuts and be careful not to cant or jam the saw blade in the kerf.
Perform all steering and control commands in a smooth and controlled fashion.
Deep cuts shall be made in several passes. Pre-cut with a small blade first and then deepen the cut with a
larger-diameter blade. Each lager blade always has to be thinner than the preceding one in order not to get
stuck in the kerf.