Lightware UBEX Series, User Manual, Page: 167 / 201

10. Firmware Upgrade UBEX series – Matrix Application Mode – User's Manual 167 10. Firmware Upgrade UBEX series – Matrix Application Mode – User's Manual 167
MA
TRIX APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
Step 3 - Set the IP Addresses of the Endpoint Devices.
Two possible methods are for completing it:
▪ via
Lightware Device Controller (LDC)
software;
▪ via using
LW3 protocol commands
.
Via LDC Software / Built-in Web
Connect to the MMU using one of the following methods:
▪ Launch the Lightware Device Controller (LDC) software and select the UBEX-MMU-X200 device in the
Device Discovery window. Connect to the MMU by clicking on the Connect button. See more details in
the
Establishing Connection section.
▪ Open a web browser application and enter the IP address of the MMU. See more details in the Software
Control - Built-in Web chapter.
Select a source or destination stream in the crosspoint area to open the properties section in the right side.
Navigate to the
Device tab
and select the
Device Properties
button to open the device properties window.
Crosspoint menu - Port properties section - Device tab in the LDC software
A pop window opens with the device properties. Navigate to the
Settings menu
and select the
Network tab
. Set
the IP address of the endpoint device (
static
or
dynamic (DHCP)
).
ATTENTION! Always click on the
Apply Changes
button before closing the Device properties window.
Device properties window - Settings menu - Network tab in the LDC software
ATTENTION! Make sure that all endpoint devices have
different static IP addresses
or the
dynamic IP address
(DHCP) is enabled
in them to avoid the IP conflict.
Repeat the procedure with all endpoint devices which are wanted to be upgraded.
Via Using LW3 Protocol Commands
Connect to the MMU using a terminal application (e.g. Putty) or use the built-in Terminal of the LDC software
/ Built-in web. See more details in the Terminal Window section.
Type the following commands
for enabling dynamic IP address (DHCP)
:
ç
SET /MEDIA/DEVICEMAP/ <logical_device_ID> /MNT/MANAGEMENT/NETWORK.DhcpEnabled=true
ç
CALL /MEDIA/DEVICEMAP/ <logical_device_ID> /MNT/MANAGEMENT/NETWORK:applySettings()
The <logical_device_ID> is the ID of the endpoint device, for example: X1, X2, X3, etc.
Example:
ç
SET /MEDIA/DEVICEMAP/X1/MNT/MANAGEMENT/NETWORK.DhcpEnabled=true
ç
CALL /MEDIA/DEVICEMAP/X1/MNT/MANAGEMENT/NETWORK:applySettings()
Repeat the procedure with all endpoint devices which are wanted to be upgraded.

  

  