LI-COR LI-600, Instruction Manual

Page: 26 / 131

Section 3. Taking Measurements
3-5
3 Clamp to leaf: Watch for stability in the g
sw
and F vari-
ables.
4 Press the Enter button to log the measurement when
your stability criteria are met.
5 Unclamp the leaf. If Prompt on log is enabled, the Data
labels screen will appear. See step 2 in "Taking a meas-
urement in Auto mode."
6 Add remark (optional): press the right arrow (Mark) to add
a remark. Select the remark and press the Enter button. You
will go back to the Measurement screen.
7 Repeat from step 3 for subsequent measurements, or press
the left arrow (Home) to go back to the Select Con-
figuration screen.
When you're done taking measurements, go back to the
Select Configuration screen, press the left arrow to
Settings . Select Shut down and press the Enter but-
ton to safely turn off the instrument.
Using the barcode scanner
To enable the barcode scanner for a configuration, see
Data Labels on page 5-5.
You will scan a barcode either before or after a meas-
urement is logged, depending on whether
Prompt on
log is enabled in the configuration (see Data Labels on
page 5-5). If it is enabled, you can scan a barcode after
each measurement. If it is not enabled, you can scan the
barcode before a measurement by pressing the right
arrow (Prompt) from the Measurement screen, and then
selecting the barcode label. If you scan the barcode
before a measurement, that barcode will apply to sub-
sequent measurements until you scan another barcode.