LevelOne IES-2881, User Manual

Page: 93 / 162

User Manual Page 93
2.
Usage:
Use this command to enable auto save configuration function. The configuration will be
automatically saved at every configured interval while this command is enabled. Use the
no form of this command to disable this feature.
3.
Command Syntax:
service auto-config enable
no service auto-config enable
4.
Example:
The following example enables or disables auto save configuration to switch:
switch_a(config)#service auto-config enable
switch_a(config)#no service auto-config enable
switch_a(config)#
Auto Save Interval (5~65536 sec):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the interval when the configuration would be automatically
saved. The range of interval value is from 5 to 65535. And the default value is 30 seconds.
3.
Command Syntax:
service auto-config interval WORD
WORD specifies the interval value.
4.
Example:
The following example sets the interval WORD ( 10 ) when the configuration would be
automatically saved to switch:
switch_a(config)#service auto-config interval 10
switch_a(config)#
Firmware Upgrade
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The
switch_a# prompt will show on the screen.
switch_a#
2.
Usage: