LevelOne IES-2881, User Manual

Page: 114 / 162

User Manual Page 114
4. Example:
The following example enables the spanning-tree edgeport of the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#spanning-tree edgeport
switch_a(config-if )#
MSTP Properties
Region Name:
1.
Command Mode: MST Configuration mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to MST Configuration mode.
The
switch_a(config-mst)# prompt will show on the screen.
switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#
2.
Usage:
Use this command to create an MST region and specify a name to it. MST bridges of a
region form different spanning trees for different VLANs. By default, each MST bridge
starts with the region name as its bridge address. This means each MST bridge is a region
by itself, unless specifically added to one.
3.
Command Syntax:
bridge GROUP region REGION_NAME
no bridge GROUP region
GROUP <1-1> Specify the bridge-group ID.
REGION_NAME Specify the name of the region.
4.
Example:
The following example creates an MST region and specifies a name ( regionname ) to it in
bridge GROUP ( 1 ):
Switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#bridge 1 region regionname
switch_a(config-mst)#
Revision Level:
1.
Command Mode: MST Configuration mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to MST Configuration mode.
The
switch_a(config-mst)# prompt will show on the screen.
switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#
2.
Usage: