LevelOne IES-2881, User Manual

Page: 141 / 162

User Manual Page 141
switch_a(config-if )#
Port Control:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2.
Usage:
Use this command to force a port state.
Use
no dot1x port-control command to remove a port from the 802.1x management.
3.
Command Syntax:
dot1x port-control auto ｜ force-authorized ｜ force-unauthorized
no dot1x port-control
auto Specify to enable authentication on port.
force-authorized Specify to force a port to always be in an authorized state.
force-unauthorized Specify to force a port to always be in an unauthorized state.
4.
Example:
The following example specifies to enable authetication on the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#dot1x port-control auto
switch_a(config-if )#
Periodic Reauthentication:
Reauthentication Period:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2.
Usage:
Use this command to set the interval between reauthorization attempts.
Use
no dot1x timeout re-authperiod command to delete the interval between
reauthorization attempts.