S E C T I O N 1 0
Troubleshooting
Only competent personnel should perform any routine maintenance and
repairs to the Level 1
®
H-1200 Fast Flow Fluid Warmer (Fluid Warmer).
The following two tables feature general troubleshooting information along
with slow flow rate troubleshooting.
General Troubleshooting Guide
Problem
Check the following:
No Power
Check to see if unit is plugged in and power is turned ON.
Be sure the unit is plugged into a working MAINS receptacle.
Disposables
Check to see that the Heat Exchanger and Gas Vent/Filter
Alarm beeps
Assembly are properly installed.
Add Recirculating
Fill reservoir to the maximum reservoir level with recirculating
Solution Alarm
solution.
Over -
If connected to a patient, close all clamps.
Temper ature
Press OFF button to clear alarm. Then, press ON button to
Alarm beeps
power on. If the Fluid Warmer continues to alarm, discontinue
use of the medical device and remove from service. Contact
Smiths Medical or your local Smiths Medical distributor.
Hot Cabinet
Check the air inlet on the bottom of the unit. Remove any
blockage or dust to insure adequate air flow.
Heat Exchanger
Lubricate O-Rings in #1 and #2 block heat exchanger sockets
hard to install
with silicone lubricant. Silicone lubricant part # 80-04-002.
Loud Compressor
Verify pneumatic tubing is fully seated into fittings.
LED doesn’t
1. Verify unit is plugged into MAINS.
light up during
2. If still no LED illumination, discontinue use of the medical
set up (on Fluid
device and remove from service.
Warmer or Air
Detector/Clamp)
Tubing doesn’t fit
Verify tubing is Level 1
®
D/DI series tubing.
in Air Detector/
Clamp
|
Operator’s Manual
52
S E C T I O N 1 0 • T r o u b l e s h o o t i n g
Summary of Contents for H-1200 115V
