level 1 H-1200 115V, Operator'S Manual, Page: 47 / 82

a
| Operator’s Manual
41
S E C T I O N 9 • O p e r a t i n g I n s t r u c t i o n s
B—Prime the Disposable Administration Set
1
Close the Disposable Set clamps above the Heat Exchanger.
• For DI-50, DI-55, D/DI-60HL, D/DI-65HL, D/DI-70, and
D/DI-75 Disposable Sets,
– close pinch clamps below the bag spikes, and
– close roller clamp below the drip chamber (
a
).
• For D/DI-100, D/DI-150, D/DI-300, and D/DI-350
Disposable Sets
– close pinch clamps below the drip chambers.
2 Remove all air from the fluid bag:
a Invert solution bag.
b
Use aseptic technique. Pierce membrane of bag port
with spike of Disposable Set. Then withdraw spike.
c
Squeeze bag to exhaust ALL air.
d
Place spike in bag port. Do not allow air to re-enter bag.
e
Repeat this step for each fluid line to be used.
3
Slide lever on H-2 Pressure Chamber to the minus (–)
unpressurized position.
4 Hang spiked fluid bag/s in Pressure Chamber:
a
Release hinged latch, open door and hang fluid bag inside
on tab appropriate for bag size.
b Close the door and secure latch.
c
Injection and Spike ports on the fluid bag should extend
from opening at the bottom of the Pressure Chambers
without being obstructed.
Note:
When installing Level 1 ® D/DI-300 and D/DI-350 series
Disposable Sets, hang the third fluid bag from the I.V. pole.
CAUTION
•
When loading fluid bags into H-2 Pressure Chambers,
choose a hanging hook that allows the bag port to hang
freely in the indented slot at the bottom of the chamber
door. If bag ports are positioned above this slot, diminished
flow could occur resulting in physical injury to the patient, user,
and/or an adverse effect on the device or its performance.
5 Open clamp above Drip Chamber on Level 1 ® DI-50, DI-55,
D/DI-60HL, D/DI-65HL, D/DI-70, and D/DI-75 Disposable
Administration Sets for each I.V. fluid bag being used to prime
the drip chamber.