level 1 H-1200 115V, Operator'S Manual

Page: 20 / 82

AX
1
2
R
LEVEL
SYSTEM 1000
a
b
c
b
a
c
14
S E C T I O N 5 • O u t o f t h e B o x — A s s e m b l y
| Operator’s Manual
Step 6
Preliminary Preparation
1
Remove the fill-port plug (
a
) on the front of the warming unit and
fill the reservoir to the maximum level with 1.4 liters of one of the
following solutions:
• 0.3% Hydrogen Peroxide/Distilled Water Solution
Mix 140 ml of 3% hydrogen peroxide and 1,260 ml of distilled
water.
Note:
If this option is selected, the maintenance requirement
to change the recirculating solution is once every 12 months.
Always use a 0.3% hydrogen peroxide/distilled water solution
when refilling the reservoir.
• Distilled Water
Note
: If this option is selected, the maintenance requirement
to change the recirculating solution is once every 30 days.
2 Replace the fill port plug.
3
Lubricate O-Rings in #1 Block (
b
) and #2 Block (
c
). Place a small
amount of silicone lubricant, provided in the supplied O-Ring Kit,
on a cotton swab and apply all around the inside of each O-Ring.
Step 7
Connect the Pneumatic Tubing
1
Locate the Accessory Pack with the black pneumatic tubing (
a
),
two “J” clamps (
b
), and one “Y” Connector (
c
).
2
Locate the orange protective plug in the red ring connector (
d
)
located on the back of the device. Remove the plug by depressing
the red plastic ring as you pull the plug out of the connector.
3
Take the pneumatic tubing and press one end of the tubing firmly
into the ring connector (
d
) until it can go no further.
4
Take the “Y” connector and press the other end of the pneumatic
tubing into the bottom of the “Y” connector, as shown (
e
), until it
can go no further.