level 1 H-1200 115V, Operator'S Manual, Page: 21 / 82

d
e
f
g
h
F1
Two Fuse Configuration
Four Fuse Configuration
F1
| Operator’s Manual
5
Press the pneumatic tubing from the Pressure Chamber
into place (
f
) on the top of the “Y” connector until it can
go no further. Repeat this procedure with the pneumatic
tubing from the other Pressure Chamber.
6
Remove the protective backing sheet on one “J” clamp,
exposing the adhesive side.
7
Carefully position the “J” clamp and press the
adhesive side against the gray I.V. Pole in the
approximate locations (
g
)(
h
) shown.
Press down firmly to secure in place.
Repeat this procedure for the other “J” clamp.
8
Press the pneumatic tubing into place on the “J” clamps.
Step 8
Install the Level 1® H-31, Version B, Air
Detector/Clamp
Before installing the Air detector, determine if the
the Fluid Warmer was manufactured before 2004.
If it is, inspect the "F1" fuse to confirm that it is the
correct value and type. The year of manufacture
can be determined by the serial number label
which is located on the bottom right side of
the unit, or for older units on the inside.
If the first four characters of the serial number
are numbers, then the numbers represent
the year of manufacture (e.g. 20040100 would be
manufactured in 2004). If the first character of the
serial number is the letter "J", then the year of
manufacture is prior to 2004 (the letter “S”
indicates the year 2007 or later). For units
manufactured prior to 2004, perform the following.
1
Disconnect the power.
2
Remove the 18 screws from the rear of the Fluid
Warmer and remove the back panel.
3
Locate the “F1” fuse on the electronic assembly.
See figures to locate the “F1” fuse for either a two
fuse configuration or a four fuse configuration.
S E C T I O N 5 • O u t o f t h e B o x — A s s e m b l y
15