level 1 H-1200 115V, Operator'S Manual

Page: 46 / 82

40
S E C T I O N 9 • O p e r a t i n g I n s t r u c t i o n s
Step 4 — H-1200 Fluid Warmer with DI-50, D/DI-60HL, D/DI-70,
D/DI-100, and D/DI-300.
4
Install the Gas Vent/Filter Assembly. Refer to the series of figures
on the left.
a Open the #3 Clamp Slot door—push down on the tab (a).
b
Lift up the front of the door (b).
c
Pull the door down (c) and away from the Clamp Slot.
d
Insert the Patient Line in the Clamp Slot (d) and push it
back into the slot.
e Hold the Patient Line in the Clamp Slot and push the
door up (e) to engage the top hinge. Then push the front
of the door down to close it.
f Pull the Patient Line to the right (f) to align it in the
Clamp Slot without kinking.
g
Align the Gas Vent/Filter Assembly to the #4 Block, (g)
and press it into place.
Step 4 — H-1000 Fluid Warmer with DI-55, D/DI-65HL, D/DI-75,
D/DI-150, and D/DI-350.
4
Install the Gas Vent/Filter Assembly.
a
Align the Gas Vent/Filter Assembly to the #3 Block,
and press it into place.
b
Press the clip at the top of the Gas Vent Vent/Filter
Assembly to the bottom of the Heat Exchanger.
c
Press the green Power ON button, located on the Power
and Alarm Test Panel, to turn ON the Fluid Warmer.
Step 4 — H-1000 Fluid Warmer with DI-50, D/DI-60HL, D/DI-70,
D/DI-100, and D/DI-300.
4
Install the Gas Vent/Filter Assembly.
a
Align the Gas Vent/Filter Assembly to the #3 Block,
and press it into place.
b
Press the green Power ON button, located on the Power
and Alarm Test Panel, to turn ON the Fluid Warmer.
| Operator’s Manual
F-50
b
a
c
d
e
f
g
F-10/30
F-10/30