Lepu Medical AIView 12V, Operator'S Manual, Page: 57 / 292

4-2
Caution
The IP addresses of the monitors configured with the remote view function
should share the same network segment. The IP addresses of the
monitors on the same LAN should be unique from each other; you cannot
use the remote view function in the monitors in which an IP address
conflict exits.
Caution
To have good remote monitoring, make sure the network connection is in
good condition.
4.2.1 Opening the Remote View Window
Before opening the Remote View window, make sure the remote
view function is configured on your monitor.
Enter the Remote View window in either of the following ways:

Press the Remote View quick key.

Press the [Screens] quick key
→
select [Remote View].

Press [Main Menu]
→
[Screens], select [Remote View].
4.2.2 Setting the Remote View Window
Press the [Setup] button in the lower right corner of the Remote View
window to open the Remote View Setup menu on which you can:

Select the waveform to be viewed on the window in the
waveform type list.
 Select the parameter to be viewed in the parameter list.

Select bed No. of the bed to be viewed in the bed No. list.
4.3 Setting the Wired Network
To set the wired network, follow the steps below:
1. Enter the network setup screen in either of the following ways:

Press the network status icon in the upper right corner of
the screen.

Press [Main Menu]
→
[System], select the [Network] tab.
2. Select the [Wired Network] tab.
3. Select how to get the IP address.
[Auto Acquire IP]: the monitor obtains the IP address automatically.
[Use IP Address below]: you need to input the [IP address], [Subnet
Mask] and [Gateway].