Lenovo ThinkSystem NE0152T, Installation Manual

Page: 37 / 110

© Copyright Lenovo 2018 Chapter 3: Installing NE0152T Hardware and Options
37
Installing the NE0152T in a Rack
The NE0152T can be rack-mounted using one of the following mounting kits:
 For a standard 19-inch equipment rack, use the 2-post rack mounting brackets
and screws included with the switch. Installation instructions begin on
page 37 .
 For a Lenovo System x or Power 4-post rack, use the Lenovo Adjustable 19”
4-Post Rail Kit. This kit must be purchased separately. Installation instructions
begin on
page 40 .
 For a Lenovo iDataPlex
®
rack, use the iDataPlex mounting kit. This kit must be
purchased separately. Installation instructions begin on page 44 .
Installing the NE0152T in a Standard Equipment Rack
This section describes how to install the NE0152T in a standard 19-inch equipment
rack using the mounting kit included with the switch. For information about
mounting the switch in other supported racks, see the appropriate section in this
chapter.
The following parts are included in the standard mounting kit.
Attention: The rack-mounting frame may be unable to support the weight of the
switch with only the front post mounting brackets (2-post application). If the switch
has an undesirable amount of sag, it is recommended to use a 4-post mounting kit.
Attention: For earthquake stability, mount the switch in a 4-post rack.
Table 9.
2-post rack mount kit parts
Item number Description Quantity
1 Mounting brackets 2
2 M4 screws 8
3 M6 screws 4
4 M6 clip nuts 4
5 M6 cage nuts 4