Lenovo ThinkServer TS200v 1008, Hardware Maintenance Manual

Page: 38 / 106

Figure 6. Removing the front bezel
4. To reinstall the front bezel, align the three plastic tabs on the right side of the front bezel with the
corresponding holes in the chassis, then pivot the front bezel inward until it snaps into position on
the left side.
5. Go to “Completing the parts replacement” on page 57.
Installing or replacing a PCI card
Attention
Do not open your server or attempt any repair before reading and understanding the Chapter 1 “About this
manual” on page 1 and the
Safety Information book. To obtain a copy of the Safety Information book,
go to:http://www.lenovo.com/support
This section provides instructions on how to install or replace a PCI card.
Your server has two standard PCI card slots, one PCI Express x1 card slot, and one PCI Express x16
card slot.
To install or replace a PCI card, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 30.
3. At the rear of the server, press the release button 1 to open the PCI card latch 2 .
32
ThinkServerHardware Maintenance Manual