Lenovo ThinkServer TS200v 1008, Hardware Maintenance Manual

Page: 46 / 106

Figure 17. Installing the optical drive
7. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 31.
8. Reconnect the signal cable and the power cable of the optical drive.
9. Go to “Completing the parts replacement” on page 57.
Replacing the secondary hard disk drive
Attention
Do not open your server or attempt any repair before reading and understanding the Chapter 1 “About this
manual” on page 1 and the
Safety Information book. To obtain a copy of the Safety Information book,
go to:http://www.lenovo.com/support
This section provides instructions on how to replace the secondary hard disk drive.
Installing a secondary hard disk drive
To install a secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 30.
3. Locate the secondary hard disk drive bay.
4. Press the release button 1 to release the secondary hard disk drive cage and then lift the cage out of
the chassis.
40
ThinkServerHardware Maintenance Manual