Lenovo ThinkServer TS200v 1008, Hardware Maintenance Manual

Page: 35 / 106

To reduce the possibility of damage from electrostatic discharge, observe the following precautions:
• Limit your movement. Movement can cause static electricity to build up around you.
• The use of a grounding system is recommended. For example, wear an electrostatic-discharge wrist
strap, if one is available. Always use an electrostatic-discharge wrist strap or other grounding system
when working inside the server with the power on.
• Handle the device carefully, holding it by its edges or its frame.
• Do not touch solder joints, pins, or exposed circuitry.
• Do not leave the device where others can handle and damage it.
• While the device is still in its static-protective package, touch it to an unpainted metal part on the outside
of the server for at least 2 seconds. This drains static electricity from the package and from your body.
• Remove the device from its package and install it directly into the server without setting down the device.
If it is necessary to set down the device, put it back into its static-protective package. Do not place the
device on the server cover or on a metal surface.
• Take additional care when handling devices during cold weather. Heating reduces indoor humidity
and increases static electricity.
Server components
The following illustration shows the major components in the server.
1
Heat sink
6
Front fan assembly
2
Microprocessor
7
Hard disk drive
3
Memory modules
8
System board
4
Optical drive
9
Rear fan assembly
5
Front bezel
10
Power supply
Chapter 6
.
Replacing FRUs
29