Lenovo 10HA, Hardware Maintenance Manual

Page: 113 / 142

8. Align the holes in the new integrated camera with the mounting studs on the bracket as shown. Then,
press the integrated camera into the bracket until it snaps into position.
Figure 50. Installing the integrated camera into the bracket
9. Position the integrated camera bracket over the front bezel so that the screw hole in the camera bracket
aligns with the corresponding hole in the front bezel. Then, install the screw to secure the camera
bracket to the LCD front bezel.
Figure 51. Installing the integrated camera bracket
10. Connect the cable to the new integrated camera. See “Parts on the system board” on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 112.
Replacing the system board and the heat sink
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
Note: Each computer has a unique Vital Product Data (VPD) code stored in the nonvolatile memory on
the system board. After you replace the system board, the VPD must be updated. To update the VPD,
see “Updating the BIOS” on page 65.
To replace the system board and the heat sink, do the following:
Chapter 9
.
Installing or replacing hardware
107