Configuration with the PC
Sources
zirkon Configuration Manual
V 1.2
53/ 148
As a standard the status is always Channel On. This
guarantees that if this functions is not used the source is
not muted.
All bus assignments in the status pre-fader remain
unaffected by this function.
The control inputs
Channel On Edge
,
Channel Off
Edge,
Ch On/Off Toggle
and
Channel Mute
control this function.
When the control signal assigned to the input
Channel On
Edge
has a positive edge the source is routed through.
When a positive edge is supplied at the input
Channel Off
Edge
then the source is muted, irrespective of the fader
position.
With rising edges supplied at the input
Ch On/Off Toggle
the status is alternated between mute and not-mute.
Channel Mute
mutes a source as long as this input is
supplied with an active signal. The source is muted with a
positive edge, with a negative edge it is routed through.
This input replaces the function Source Mute.
The functions Channel On/Off Edge and Channel Mute
should not be used in combination. In this case a Channel
Mute should be used in combination with Channel On/Off
via separate logic functions (TFF-OR or IMP-OR).
Information about the source status you acquire via the
control outputs
Channel On
and
Channel Mute
.
When a faderstart in combination with Channel On is
required they can be linked by an AND gate.
Note
