Configuration with the PC
Preparation
34/ 148
V 1.2
zirkon Configuration Manual
Installation
Before installing the application you have to assure in any
case that the MDAC driver version 2.5 and Microsoft JET
4.0 SP6 are installed.
1.
Double-click on the programme system!
The installation programme is started.
2.
Follow the instructions of the programme!
3.
Click on “Ready” to finish the installation!
The configuration programme is fully installed on your
system.
Starting the configuration software
1.
Double-click on the zirkon symbol!
The configuration programme starts with a blank screen.
Preparation
Checking the connection
Before transferring your settings to the zirkon system you
should check the connection first. This is performed the
easiest way by using the ping command in the “DOS”
box”.
1.
Open the MS DOS prompt!
2.
Enter the following syntax:
“cd..“
“cd programme\zirkon“
3.
Enter the following command:
ping 192.168.101.240 (ex works settings)
The zirkon confirms! If you have set another IP address please
use this!
After the system confirmed you can carry on. If the
system does not give out a confirmation please read the
paragraph “Download setup – when something went
wrong” in the chapter “Error messages”.
When the zirkon system is connected with a network then
proceed as follows:
