![background image](http://html1.mh-extra.com/html/land-pride/pfs4000/pfs4000_operators-manual_3508961025.webp)
Section 4: PFS8010 Assembly & Set-Up
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
21
The following instructions are for the PFS8010 model.
See page 16 for PFS4000 and page 18 for PFS5060
models. See page 14 for drive unit assembly instructions.
Connecting Hooks & Hook-Up Bar
Refer to Figure 4-1:
1. Orient shaped hook-up bar (#4) with guide lug “A” on
the right side as shown.
2. Insert shaped hook-up bar into slots “B” & “C” with
circular guide plates outside the slots.
3. Hold hook-up bar against top of slots while attaching
hooks (#1) to the main frame with M10 x 35 (1 3/8")
bolts (#2) and self locking hex nuts (#3).
4. Make certain right hand hook is positioned under
guide lug “A” and then tighten self locking nuts (#3) to
the correct torque.
Drive Unit Assembly to Main Frame
Refer to “Section 1: Drive Unit Assembly” on page 14 for
instructions on how to assemble the drive unit.
Refer to Figure 4-2:
1. Insert M12 x 50 (2") bolts (#5) into front holes and
M12 x 40 (1 1/2") bolts (#3) into the back holes of
drive frame (#1).
2. Attach drive frame (#1) to holes “B” and “A” in
mounting plate (#2) with hex nuts (#4 & #6). Do not
tighten hex nuts at this time.
3. Press end caps (#7) into the tube ends.
IMPORTANT:
Drive Unit assembly is heavy and
requires 2 people to safely install to the main frame.
Do not tighten nuts (#4 & #6) until after hopper is
installed. This will allow for proper alignment of
hopper to drive unit assembly.
NOTE:
If rear bolts (#3) are difficult to install into
holes “A” in mounting plate (#2), pivot rear of drive
unit up and down to insert bolts through holes “A”.
Section 4: PFS8010 Assembly & Set-Up
3-Point Hook Assembly
Figure 4-1
Drive Unit Assembly
Figure 4-2
30770
30769
2" Lg. Bolts
1 1/2" Lg. Bolts