![background image](http://html1.mh-extra.com/html/land-pride/pfs4000/pfs4000_operators-manual_3508961024.webp)
Section 3: PFS5060 Assembly & Set-Up
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
20
Hopper Assembly
Refer to Figure 3-3:
1. Orient hopper (#1) with decals facing front as shown
and lower hopper onto hopper support ring (#6).
Make certain drive unit (#5) is centered under the
hopper bottom. (Land Pride Logo is on the back.)
2.
Refer to
Make any final
adjustment to the drive unit and then tighten hex
nuts (#4 & #6) to the correct torque.
3. If included, install optional hopper extension at this
time. See “Hopper Top Extension Kit” on page 30 for
installation instructions.
4. Using holes in hopper support ring as a template,
slowly drill 10 mm (13/32") holes up from the bottom
of the support ring through the hopper flange.
Hopper Assembly
Figure 3-3
NOTE:
Make certain hopper is fully seated against
hopper support ring on all four sides before
continuing with step 2 below.
30767
Locate & drill holes
in hopper flange in
field assembly.
5. Attach hopper to hopper support ring with
M10 x 60 (2 3/8") round head screws (#2), flat
washers (#3) and hex head nuts (#4). Do not tighten
nuts until after all bolts and nuts have been installed.
6. Hand tighten nuts (#4) with a hand wrench. Do not
use a power wrench.
Gate Lever Assembly
Refer to Figure 3-4:
1. Insert gate lever (#1) into mounting bracket (#2) as
shown and secure with compression spring (#3), flat
washer (#4) and M16 self locking hex nut (#5). Draw
nut up snug, do not tighten.
2. Spread fork on end of regulation bar (#6) and attach
gate lever (#1) to regulation bar with M6 x 25 (1") hex
bolt (#7) and hex nut (#8).
3.
See Detail “A”:
Draw hex locknut (#8) up until bolt
has approximately 3/32" movement.
4. Attach handle (#11) to gate lever extension (#10).
5. Attach gate lever extension (#10) to gate lever (#1)
with PVC sleeve (#9).
6. Tighten nylock nut (#5) until lever (#1) has enough
resistance to not move during field use. Some
adjustment to nut (#5) may be required during field
application. Make sure nylock nut has full thread
engagement.
7. Turn to page 24 for “Driveline Assembly and Set-Up”
instructions.
Gate Lever Assembly
Figure 3-4
30768